Planning & measuring guide
A few careful measurements now will save time and money later. Ask your fitter to check your plan before you order.
1. Measure the room
Draw a rough plan of the room. Measure each wall at worktop height and near the floor, in millimetres. Mark doors, windows (with sill heights), radiators, boiler, gas and water pipes, sockets and the soil pipe. Measure the ceiling height in several places.
2. Plan the run of units
- Base units are 720mm high on legs; with a standard 38mm worktop the finished worktop height is around 900mm.
- Common unit widths are 300, 400, 450, 500, 600, 800, 900 and 1000mm. Fill odd gaps with a narrow pull-out or a filler panel.
- Leave space for appliances: most integrated dishwashers and washing machines need a 600mm space.
- Corner units need clearance so doors and drawers on the next run can open. Allow for handles.
3. Wall and tall units
Line wall units up with the base units below. Leave the space your hob or hood manufacturer recommends above the hob. Tall units for ovens and fridge freezers must match your appliance’s housing dimensions; check the appliance’s installation guide.
4. Finishing pieces
- Plinths run along the bottom of base and tall units. Measure the total run, plus returns at the ends.
- End panels cover any exposed cabinet sides.
- Worktops: add the total run plus overhangs, and allow for joints at corners. Order upstands for the walls.
- Handleless kitchens need rails along each run of doors and drawers.
5. Build and check your list
Use the kitchen planner to add units by width and see a running total, then share the plan with your fitter. If you’d like us to check it, send it to us.
Wardrobe doors
Measure the width of your opening at the top, middle and bottom, and the height at the left, middle and right. Use the smallest measurements. Sliding doors overlap by 26mm, so two doors cover twice the door width minus 26mm. See fitted wardrobe doors for a size table.